Close view of a repaired section of a concrete tile roof on a Tempe stucco home: new metal valley flashing and neatly reset tiles around a plumbing vent pipe, late afternoon sun, blue sky

Tempe Roof Leak Repair

Roof Leak Repair in Tempe, AZ

We follow the water back to where it got in, then fix that spot instead of smearing sealant around it.

Roof Leak Repair for Tempe Homes

A ceiling stain rarely sits directly under the hole. Water lands on the underlayment, runs downhill along a batten or rafter, and drips somewhere else. That's why so many leak "repairs" don't hold.

We start in the attic when there's access, mark where the decking is stained, and then trace uphill on the roof. On tile roofs we lift tiles around the suspect area. On shingle and foam roofs we check every seam and penetration nearby.

Most Tempe leaks we find come from four places: roof-to-wall flashing, valleys, plumbing vents and the edges of rooftop AC stands. Each one has a proper fix.

Get a Free Estimate

Brown water stain spreading on a white textured ceiling near a light fixture inside an Arizona home, a small bucket on the tile floor below

Where Tempe Roof Leaks Usually Start

Wall flashing

Where a roof meets a stucco wall or chimney, old flashing pulls loose and water gets behind it.

Clean new metal valley pan running down between two planes of a concrete tile roof, tiles neatly cut along the edges

Valleys

Debris dams up the valley and rust opens holes in older metal pans.

Plumbing vent pipe and a roof jack on a tile roof with new flashing and sealant, close detail

Pipes and vents

Cracked rubber boots and dried-out lead jacks around plumbing vents.

Inside a residential attic with wood trusses and insulation, a flashlight beam showing a dark water stain on the roof decking, no people

Hidden damage

Stained decking in the attic shows how far the water has traveled.

Patch, Repair or Replace?

Situation	What we usually recommend
One leak, underlayment still flexible	Repair the flashing or penetration and reset the tiles
Repeat leaks in one area	Replace the underlayment in that section
Leaks in several areas of a tile roof	Tile underlayment replacement across the roof
Shingles brittle and curling everywhere	A new shingle roof rather than another patch

How a Leak Repair Works

Look inside. We check the ceiling, the attic and the decking to see where water has been.
Trace it outside. Tiles lifted or seams checked uphill from the stain until we find the entry point.
Show you. Photos of the cause and a written price for the repair.
Fix it. New flashing, boot or underlayment, then tiles reset or shingles woven back in.
Confirm it. We recheck after the next good rain if you'd like, at no charge.

Roof Leak Repair Questions

Why does my roof only leak in heavy monsoon rain?

Wind-driven rain gets pushed sideways under tiles and into flashing laps that stay dry in a gentle shower. Those leaks usually point to a flashing detail or worn underlayment, not a hole you can see.

Can you find a leak when it isn't raining?

Usually. Water leaves stains and rot on the decking, and worn flashing is visible once tiles are lifted. We can also water-test a suspected spot with a hose.

Is roof sealant a real fix?

Rarely for long. Sealant shrinks and cracks in Tempe's summer heat. We use it only as a secondary seal behind proper metal flashing.

Should I fix the ceiling first?

No. Fix the roof first and let the drywall dry out. Then repair the ceiling once you know the leak has stopped.

Get a Free Leak Inspection

Tell us where the stain is and when it shows up. We'll trace it to the source and send photos.

Call 602-905-0525

Free estimate, no obligation